Display spectrum of sine wave in Simulink
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
As a simple experiment, I am trying to generate a sine-wave and display its spectrum with the spectrum analyzer. I am expecting a narrow peak at the chosen frequency of the sine, which is 1MHz. However, what I get is a "smeared" spectrum, although the frequency should fall on a single bin. What am I doing wrong?
1 comentario
Aquatris
el 19 de Feb. de 2024
Editada: Aquatris
el 19 de Feb. de 2024
I think you still have leakage due to how the block works. Change the 'window length' (by default it is RBW) and it prevents the leakage. I have never used this block before so I cannot tell in detail what might be the correct way.
Respuestas (1)
Pramil
el 26 de Feb. de 2024
You are getting smeared peaks due to spectral leakage. I assume that you are using the “Filter bank” method for frequency resolution if not I recommend using that and increase the sharpness to “1” for getting narrow peaks.
You can refer to this page under “Frequency Resolution” section to knwo more about “Filter bank” method:
You can also add a “Lowpass Filter Block” to supress higher frequency components which reduces attenuation due to high-frequency noise.
I have attached a sample model for you to refer.
0 comentarios
Ver también
Categorías
Más información sobre Spectral Measurements en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!