Using dynamic workspace arrays as Matlab function input/output
1 visualización (últimos 30 días)
Mostrar comentarios más antiguos
Niklas Braun
el 30 de Nov. de 2020
Respondida: Fangjun Jiang
el 1 de Dic. de 2020
Hey there,
i want to create a Simulink model, where the following happens:
- Based on Simulink signal values as input, an array of possible responses shall be created/extended in Matlab base workspace. If the input signals do not change in between simulation steps, the array shall not be extended.
- After that, a separate Matlab function Block should choose values from this array, process them and create Simulink output values. The values, which were used to generate the output values shall be removed from the list (or marked as used)
So far, I have created a Matlab function block, which takes the simulink signal, as well as a constant, which points to the list in the Matlab workspace, as input. And outputs the updated list. How can i write the updated list in the workspace?
2 comentarios
Fangjun Jiang
el 30 de Nov. de 2020
Why involve MATLAB base workspace? The interface between your part 1 and part 2 could be an ordinary signal, a vector signal or array signal.
Respuesta aceptada
Fangjun Jiang
el 1 de Dic. de 2020
- Use vector signal between part 1 and part 2. No need to use memory block. Use Unit delay to resolve algebric loop if needed.
- Use global variable if don't want to bother the signal interface. See https://www.mathworks.com/help/releases/R2020b/simulink/ug/using-global-data-with-the-matlab-function-block.html
- variable-size signal is supported
0 comentarios
Más respuestas (0)
Ver también
Categorías
Más información sobre Sources en Help Center y File Exchange.
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!