Operaciones lógicas y de bits
R2026aBloques de operaciones lógicas o bit a bit, como Logical Operator y Relational Operator
Utilice los bloques de la biblioteca Logic and Bit Operations para detectar cambios en los valores de las señales, realizar operaciones lógicas o relacionales en las entradas y convertir los bits en enteros.
Bloques
 | Bit Clear | Set specified bit of stored integer to zero |
 | Bit Set | Set specified bit of stored integer to one |
 | Bit to Integer Converter | Map vector of bits to corresponding vector of integers |
 | Bitwise Operator | Specified bitwise operation on inputs |
 | Combinatorial Logic | Implement truth table |
 | Compare To Constant | Determinar cómo se compara la señal con una constante especificada |
 | Compare To Zero | Determinar cómo se compara la señal con cero |
 | Detect Change | Detectar cambios en el valor de una señal |
 | Detect Decrease | Detect decrease in signal value |
 | Detect Fall Negative | Detect falling edge when signal value decreases to strictly negative value, and its previous value was nonnegative |
 | Detect Fall Nonpositive | Detect falling edge when signal value decreases to nonpositive value, and its previous value was strictly positive |
 | Detect Increase | Detect increase in signal value |
 | Detect Rise Nonnegative | Detect rising edge when signal value increases to nonnegative value, and its previous value was strictly negative |
 | Detect Rise Positive | Detectar el flanco ascendente cuando el valor de una señal aumenta a un valor estrictamente positivo y su valor anterior era no positivo |
 | Extract Bits | Output selection of contiguous bits from input signal |
 | Float Extract Bits | Extract bits from floating-point input samples (Desde R2023a) |
 | Integer to Bit Converter | Map vector of integers to vector of bits |
 | Interval Test | Determine if signal is in specified interval |
 | Interval Test Dynamic | Determine if signal is in specified interval |
 | Logical Operator | Perform specified logical operation on input |
 | Relational Operator | Perform specified relational operation on inputs |
 | Shift Arithmetic | Shift bits or binary point of signal |
