Open MDF-files and access information about the file and its contents.

Read channel data from an MDF-file.

Read channel data applying conversion rules from an MDF-file, and configure different reading options in MATLAB.

Import and decode CAN data from MDF-files in MATLAB for analysis. The MDF-file used in this example was generated from Vector CANoe™ using the "CAN - General System Configuration (CAN)" sample. This example also uses the CAN database file, PowerTrain.dbc, provided with the Vector sample configuration.

Use the MDF Datastore feature of Vehicle Network Toolbox to quickly and efficiently process a data set spread across a collection of multiple MDF files. This workflow is also valuable when there is too much data to fit into available memory.

Investigate vehicle battery power during discharge mode across various drive cycles. The data for this analysis are contained in a set of vehicle log files in MDF format. For this example, we need to build up a mechanism that can "detect" when the vehicle battery is in a given mode. What we are really doing is building a detector to determine when a signal of interest (battery power in this case) meets specific criteria. When the criteria is met, we will call that an "event". Each event will be subsequently "qualified" by imposing time bounds. That is to say an event is "qualified" if it persists for at least 5 seconds (such a qualification step can help limit noise and remove transients). The thresholds shown in this example are illustrative only.

Programmatically map MDF channels and consume their data via input ports of a Simulink model. It performs the gathering of input port names of a Simulink model and correlates them to the contents of a given MDF-file. A linkage between them is then created which consumes channel data sourced from the MDF-file when the model runs.

Import a calibration data file into MATLAB, examine and modify its contents, and export the changes back to a file on disk.

Use calibration data from a CDF file as inputs to a Simulink model.

Store calibration data from an ASAM CDFX file in a data dictionary and use these values as parameters to a Simulink model.

Import and decode CAN data from BLF-files in MATLAB for analysis. The BLF-file used in this example was generated from Vector CANoe™ using the "CAN - General System Configuration (CAN)" sample. This example also uses the CAN database file, PowerTrain_BLF.dbc, provided with the Vector sample configuration.