Triggering video stream with AND gate.

I would like to trigger live video stream with the use of AND gate in Simulink. I used 'from video device' block followed by enabled trigger, which is getting control signal from AND gate and obtaining it's display on video device block. The problem is, it is not generating HDL code for enabled subsystem, triggered subsystem and reset. Please suggest another block which can replace enabled subsystem. So that i can generate HDL code.

Answer 1

[Kiran Kintali]

Control based subsystems (enable, triggered, resettable subsystems) are not supported at DUT level. Please consider creating one more level of hierarchy by creating additional subsystem and try HDL code generation.

[ketan zamre]

Thanks for your response Kintali. I tried creating subsystem before for Enabled subsystem block but HDL coder doesn't able to find Enabled subsystem. Error: Specified HDL code generation system 'KetanTrigger/Enabled Subsystem' does not exist in model.

Answer 2

[Bharath Venkataraman]

I believe that Kiran is asking you to put the enabled subsystem into a subsystem. TO do this, select the enabled subsystem and hit Ctrl-G. Then, generate HDL code for the top level subsystem (and not the enabled subsystem below).

[ketan zamre]

I did the same, but then while generating HDL code, it gives error: Specified HDL code generation system does not exist in model.

[Bharath Venkataraman]

Can you show the top-level model again with the new subsystem? You need to say makehdl(<top level subsystem name>) or right click on the subsystem and choose HDL code generation.