MATLAB Answers

How to use boolean to control switch with fixed point data.

7 views (last 30 days)
Joshua Wright
Joshua Wright on 15 Apr 2019
Commented: Joshua Wright on 17 Apr 2019
I am trying to use a boolean output from inside of Matlab function block to control a switch, which has 16-bit fixed point data. However, I keep getting the following error:
This assignment writes a 'logical' value into a 'double' type. Code generation does not support changing types through assignment. Check preceding assignments or input type specifications for type mismatches. Function 'FSM' (#1424.358.366), line 20, column 13: "path_sel" Launch diagnostic report.
It appears to force my output into a double type and fails. I noticed if I leave the switch data inputs open (floating) it runs fine and interprets the switch states as T and F.

Answers (2)

Fangjun Jiang
Fangjun Jiang on 15 Apr 2019
You set the criteria of the Switch block as u2>=1, which implies that u2 is double data type. Through back propagation, it requies "path_sel" to be double.
Just change the criteria of the Switch block to be "u2~=0"
Joshua Wright
Joshua Wright on 15 Apr 2019
Did not see any speicification on the delay unit. I tried removing the delay and directly connecting but had the same errors.

Sign in to comment.

Bharath Venkataraman
Bharath Venkataraman on 17 Apr 2019
S1 and S2 when they are assigned to mealy_state_reg likely need to be fixed point.
Try using assignements as follows:
mealy_state_reg(:) = S1;
mealy_state_reg(:) = S2;
  1 Comment
Joshua Wright
Joshua Wright on 17 Apr 2019
I added a convert block to ufix1 and that resolved the issue.

Sign in to comment.




Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by